MIDIbox Hardware Platform
R3 DOUT Module

Click here for documentation for past revisions

Live Board Map:

Move your mouse around over the image below to see info on the parts.

Parts List:

MBHP DOUT Orderlist (last update: 06-2006)
+-------+------------------------------------+-----+------------------+
| Loc.  | Description                        | Qty | Mouser Part #    |
+-------+------------------------------------+-----+------------------+
| IC1-4 | 74HC595                            |  4  | 511-M74HC595     |
| IC1-4 | IC-Sockets for 74HC595             |  4  | 571-3902614      |
| RP1-4 | 220 Ohm 16 Pin DIL resistor network|  4  | 652-4116R-1LF-220|
| C1-4  | Ceramic Cap 100nF=.1uF "104"       |  4  | 80-C412C104K5R   |
| Jxx-- | 2-row DIL Headers (60 pins)        |  1  | 517-2380-6221TN  |
+-------+------------------------------------+-----+------------------+
1.  Alternate loading:
    32 discrete 220 Ohm resistors can be loaded instead of DIL 
    resistor packs, Substitute:
    | RP1-4 | 220 Ohm 16 Pin DIL resistor network|  4  | 652-4116R-1LF-220|
    With:
    | R1-32 | Resistor 220 Ohm                   |  32 | 291-220          |


PCBs and Kits are available: Click to order.



PCB Quick View:


Alternate loading using discrete resistors:


Alternate loading for driving relays:


Connections:


# Location Detail Description                              
J1 Interface to CORE:J8 (if LEDs are used) and CORE:J7 (if LED-Rings are used, MIDIbox16E only). DOUTX4:J1 provides two power pins for 5V/0V, the serial clock, the latch enable and the serial input of the register chain.
This port can also be connected with J2 of another DOUTX module.
J2 Interface to another DOUTX4 module. DOUTX4:J2 provides nearly the same pins like J1, just only the serial input of the first IC is replaced by the serial output of the last IC.
This port can be connected with J1 of another DOUTX module.
J3 Digital output lines.
J4 Digital output lines.
J5 Digital output lines.
J6 Digital output lines.

Changelog:

Changes from R2 PCB:
Double sided PCB design.
Plated through holes.
Green LPI solder mask both sides.
HASL pad plating.
White topside legend silkscreen.
All jumpers eliminated.
2x5 DIL pinheader footprint, pads and holes added to all connections.
Bypass caps added.
Added pads for ULN2803s to allow for easy relay drive.


For complete technical info and instructions see www.midibox.org

Last update: 06-30-2006 by SmashTV

MIDIbox Copyright © 1998-2006, Thorsten Klose. All rights reserved.
This page Copyright © 2003-2006, SmashTV. All rights reserved.